Rob is a pool-service industry professional with over 20 years of experience. Source Step 1: Adjusting Salinity Salt level Before the chlorine generator can be calibrated correctly, the salinity—or salt level in the pool water—will need to be at the correct level. For these systems, it should ideally be between ppm parts per million. This can be tested using a salt test meter or salt test strips. This meter is very accurate and also measures pH and chlorine levels. It is also important for any salt chlorination system that the stabilizer level in the pool water is between ppm.

Author:Tygojin Vijinn
Language:English (Spanish)
Published (Last):14 July 2018
PDF File Size:6.40 Mb
ePub File Size:9.38 Mb
Price:Free* [*Free Regsitration Required]

Page 4: Operation The operation requires a low concentration of salt sodium chloride in the pool water. These levels are low enough that it normally will not be tasted. The Aqua Rite automati- cally sanitizes your pool by converting the salt into free chlorine which kills bacteria and algae in the pool. Be sure to tell the pool store that you are using an Aqua Rite chlorine generator. Saturation index The saturation index Si relates to the calcium and alkalinity in the water and is an indicator of the pool water "balance".

Page 6 If the level is low, determine the number of gallons in the pool and add salt according to the chart on page 4. A low salt level will reduce the efficiency of the Aqua Rite and result in low chlorine production. Page 9: Controls Aqua Rite has stopped generating chlorine. A flashing LED indicates a second time delay period. When illuminated steady, the salt level is too low and Aqua Rite has shut down.

Page 10 4. Push the Diagnostic button to exit. This setting is used to control the amount of chlorine the Aqua Rite generates. The Pro Logic, Intellitouch or Eos can fully control the function of the Aqua Rite chlorinator in addition to the other pool equipment. This information can be found on page 1. Page Installation Aqua Rite system. Mounting the Aqua Rite Control The Aqua Rite is contained in a raintight enclosure that is suitable for outdoor mount- ing.

The control must be mounted a minimum of 5 ft. Consult local plumbing codes. The Aqua Rite is packaged with a flow switch and cell unions. The cell must be pur- chased separately. Refer to page 1 for information about available chlorinator cells. The preferred installation is after downstream all the pool equipment filter, heater, solar, etc.

It is very important that the Aqua Rite is powered only when the pump is running. Any outdoor rated 4 conductor cable can be used. Page Troubleshooting Aqua Rite control. Verify input voltage with a voltmeter. If there is input power, the fuse may have blown. The Aqua Rite is protected by a 20 amp mini ATO fuse located on the circuit board above the cell connector.

This manual is also suitable for:.





How to Calibrate a Hayward Goldline Aqua-Rite or Swim Pure Plus Pool Salt Chlorine Generator



Goldine Controls Aqua Rite Operation And Installation Manual


Related Articles